Vol. 58 No. 7 CONTENTS
Special Issue on
X-ray Study of Mechanical Behavior of Materials
General Paper

Special Issue on X-ray Study of Mechanical Behavior of Materials (Vol.58 No.7)

Foreword

Y.Akiniwa

561

Original Paper (Vol.58 No.7)

Internal Stress in EB-PVD Thermal Barrier Coatings under Thermal Cycle

Kenji SUZUKI and Takahisa SHOBU

562

Measurement of Plastic Strain Distribution by Electron Backscatter Diffraction

Masayuki KAMAYA

568

Measurement of Residual Stress Distribution in Sputtered Cu Thin Films by X-Ray Method

Yoshiaki AKINIWA, Hidehiko KIMURA and Taku SAKAUE

575

Estimation of Residual Stress and Strength in Fiber-Textured TiN Hard Thin Film

Yoshiaki AKINIWA, Takuya WATANABE and Hidehiko KIMURA

581

Hybrid Measurement of CT and Strain Distribution of Fatigue Crack in Steel Bars Using High Energy Synchrotron Radiation Monochromatic X-Ray

Takahisa SHOBU, Keisuke TANAKA, Atsushi HASHIMOTO and Jun-ichi NARITA

588

Observation of Internal Crack of Steel Bar by Computed Tomography and Strain Mapping near Its Tip Using Synchrotron White X-Ray

Jun-ichi SHIBANO, Kouji KIRIYAMA, Kentaro KAJIWARA, Takahisa SHOBU, Kenji SUZUKI, Takayuki ARAI, Setsuo MIURA and Michiaki KOBAYASHI

596

Measurement of Local Stress Components in Single Crystal Alumina by Using Raman Microspectroscopy with Sub-Micro Spatial Resolution

Hirohisa KIMACHI, Shinji YAMAMOTO, Wataru OTA, Kaori SHIRAKIHARA and Yuichi FUJITA

603

Fatigue Strength and X-RayTriaxial Residual Stress Measurement of Annealed Fine Grained Steels Processed by Shot-Peening

Katsuhiro SEKI, Masayuki SHOZU, Masahide GOTOH, Munetoh HASHIMOTO, Toshihiko SASAKI and Yukio HIROSE

610


General Paper (Vol.58 No.7)

Original Paper (Vol.58 No.7)

Study on the Maximum Load-Carrying Capacity and Durability of RC Slabs with UFC Permanent Forms under Running Loads

Tadashi ABECAya NIIMICTetsukazu KIDA and Satoshi TANAKA

619

FEM Analysis Study on Fatigue Strength and Fracture Morphology in Spot Welded Joints of Structural Steels

Keiichiro TOHGO, Tomoya OHGUMA, Yoshinobu SHIMAMURA and Yoshifumi OJIMA

627

Evaluation of Interfacial Properties for Carbon Fiber/Polyamide Model Composites by Means of Single Fiber Pull-Out Test

Kazuto TANAKAC Yuki MASABE and Tsutao KATAYAMA

635

Compression Molding of Carbon Fiber Reinforced Thermoplastics Using Non-Woven Stitched Multi-Axial Cloth by Means of Induction Heating System

Kazuto TANAKA, Norio KOHASHI, Yohei KINOSHITA, Tsutao KATAYAMA and Kazutaka UNO

642

Lecture (Vol.58 No.7)

Degradation/Damage Measurement and Life Assessment of High-Temperature Components ‡V: Heavy-duty and Aero Gas Turbines

Yomei Yoshioka and Akira Yamashita

649