The Effects of Fine Particle Peening on Surface Residual Stress of a TRIP-Aided Bainitic Ferrite Steel
Masahiro NATORI, Sung-Moo SONG and Koh-ichi SUGIMOTO
Abstract:To apply a transformation-induced plasticity (TRIP)-aided steel consisting of bainitic ferrite structure matrix and metastable retained austenite of 10 vol% (TBF steel) to some precision gears, the effects of fine particle peening on the Vickers hardness and residual stress in a surface layer of the TBF steel were investigated. The peened surface layer showed much higher Vickers hardness and compressive residual stress than those of a quenched and tempered SNCM420 steel. The increased Vickers hardness was mainly caused by an increase in the strain-induced transformed martensite fraction. The compressive residual stress was increased by the increases in size and gravity of shot material and arc-height. The higher compressive residual stress was principally associated with (1) plastic strain due to severe plastic deformation and (2) expansion strain due to the strain-induced transformation of metastable retained austenite. Contribution of the (2) was approximately 30% of total residual stress. Key Words:Residual stress, Hardness, Surface hardening, Fine particle peening, Retained austenite,TRIP-aided steel, Strain-induced transformation