Vol. 51 No. 11 CONTENTS
Special Issue on Corrosion and Protection
General Paper

Special Issue on Corrosion and Protection (Vol.51 No.11)

Review paper (Vol.51 No.11)

Succession of Corrosion Preventive Technologies and Their Application -To Overcome Never Ending Corrosion Problems-

Masao OKUBO

 1181

Reliability of Materials for Used in Chemical Plants

Hiroshi IMAGAWA

 1190

Original Paper (Vol.51 No.11)

Effects of Solution pH, Sodium Chloride and Amino Acids on the Corrosion of a Steel Plate in Lime Water

Yutaka TSURU, Yuji TAMAE, Youko NAGAI, Tomomi NAKAHATA and Katsu MATSUI

 1197

Prediction Method of Corrosion of Ductile Iron Pipes by A.C. Impedance Measurment Method

Hiroaki FUJII, Toshihiro KUBO, Hiroaki SHIMIZU, Yukio KATANO and Toshio SHIBATA

 1203

A Corrosion Protection Methed for Preventing Corriosion Due to Inner-Jumping Current in High-Temperature, High-Pressure Water Pipelines

Akinobu NISHIKAWA and Hidemasa NONAKA

 1210

Corrosion of Copper in a Thin-Solution Layer of Concentrated Aqueous Solution of Lithium Bromide

Atsushi NONAKA and Hidemasa NONAKA

 1218

Correlation between Preferred Orientation and Pinhole Defect of TiN Films by Ion Mixing and Vapor Deposition Techique

Hitoshi UCHIDA, Masato YAMASHITA, Satoshi HANAKI and Hiroyuki KAGAWA

 1223


General Paper (Vol.51 No.11)

Review paper (Vol.51 No.11)

Development of Photonic Crystals for Microwave Control by Using Stereilithography

Soshu KIRIHARA and Yoshinari MIYAMOTO

 1229

Original Paper (Vol.51 No.11)

Effect of Sintering Additives and SiC on High Temperature Oxidation Behavior of Silicon Nitride

Keiji HOUJOU, Kiyohito HIRAI, Kotoji ANDO, Min-Cheol CHU, Sinya MATUSITA and Sigemi SATO

 1235

Estimation of Steady State Creep Behavior of Al2O3/YAG Eutectic Composite by Image-Based Finite Element Analysis

Noriyuki MIYAZAKI, Toru IKEDA and Toshihiro KOMURA

 1242

Stress Corrosion Crack Propagation Behaviour of Ultra-Fine Grained Copper Produced by Equal-Channel Angular Pressing Technique

Takashi YAMASAKI Hiroyuki MIYAMOTO and Takuro MIMAKI

 1248

Stress Singularities at the Frictional Contact Interface Edge with Small Slipping

Jin-Quan XU and Yoshiharu MUTOH

 1253

Effect of FOD on Fatigue Strength of Ti-6Al-4V Alloy

Hisao MATSUNAGA and Yukitaka MURAKAMI

 1259

Sintering Behavior, Electrical and Mechanical Properties of Barium Titanate Ceramics Doped with BaB2O4

Nobuyuki TAKEUCHI, Yuji YAMASAKI and Shingo ISHIDA

 1267

Development of Incombustible RW Absorbers Using Carbon Fiber-Reinforced Superlightweight Polymer-Modified Mortars

Yukuo SHINOZAKI and Kazuo SHIMADA

 1271

Investigation of Durability of Reinforced Concrete Member on Land Repaired by Electrodeposition Method

Nobuaki OTSUKI, Takahiro NISHIDA, Hiroshi MINAGAWA and Wanchai YODSUDJAI

 1278

Lecture (Vol.51 No.11)

Impact-Load Behavior of Materials and Its Evaluation Techniques Ⅱ:Impact Problems and Numerical Simulation

Toshio Imaki and Sunao Tokura

 1284